22mm Carby Carburetor Intake Manifold Throat 125cc PIT Quad Dirt Bike ATV Buggy

Fit on 22mm handle bar.

Measurement(approximately) :

 Eye center to center:  235mm
 Mounting hole diameter: 8mm, fit our 6.5hp/9hp go karts.

23T Spline 4 Stud 25mm Rear Axle Wheel Hub will fit Quad/Dirt Bike/ATV/UTV/Buggy.

This listing is for 1 hub, not 2 hubs. Thanks

2420mm(242cm) Throttle Cable For 200CC 6.5HP 9HP 270CC Dune Buggy GoKart

Fit most 250cc water-cooled buggies ,Kinroad Sahara,Kandi. Twister/Hammer.

BRAND NEW

25mm Axle Assembly  Length 845mm

It fits our mini Willy Jeep with a back engine.

Fit Most

JEEP, Project, Go Kart, HuFFy Slider, Drift Trike.

BRAND NEW

25mm Axle Assembly  Length 850mm

Fit Most

JEEP ,Project, Go Kart, HuFFy Slider ,Drift Trike.

This listing is for 1x shock.

This Shock fits on our mini Willy Jeep as the rear shock.

Eye to Eye center: 270mm

Bolt hole: 10mm

Spring diameter:8mm

Measurement(approximately) :

 Eye center to center:  275mm
 Mounting hole diameter: 10mm,

This shock comes with a spring of 6mm thickness, and a mounting hole of 10mm.

Length: center to center 285mm.

It is used on our 9hp kart as a front shock.

You will receive 1x shock for this listing.

This listing is for 1x shock.

This Shock fits on our mini Willy Jeep as the front shock.

Eye to Eye center: 290mm

Bolt hole: 10mm

Spring diameter:8mm

Brand New Gearbox

This set is used on our 9hp go-kart/drift trike.

These replacement clutch boxes come as complete units and are ready to be fitted to your engine.

Fits the Honda GX240 - GX390 range and most Chinese 9hp to 13hp clone engines with 25mm diameter and 60mm long output shafts, also known as the L-type PTO shaft option.

Requires a 60mm long, 25mm diameter crankshaft input, output is to a 22mm shaft, also known as the R-type PTO shaft.

Ready to assemble, they give incredible torque at lower engine speeds and are ideal replacements on go-karts, mixers, pumps, etc.

This is a carefully selected replacement part of the highest quality, and also at an affordable price too.

DETAILS:

• Type: 2:1 Reduction
• Input Shaft: 25mm Diameter, 60mm Long
• Input Shaft Keyway: 7mm
• Input Mounting Holes: 90mm Square

• Output Shaft: 22mm Diameter, 50mm Long
• Output Shaft Keyway: 7mm
• Output Mounting Holes: 70mm Square

Please Note: The gearbox is supplied without oil, and requires oil before use. This is typically the same as you would use in the engine sump i.e an SAE30 4-stroke small engine oil.